Petrochemical site seen from outside, distillation towers, under a clear blue sky — CDL-Tecora

Gas purity control

Chemicals & Petrochemicals

Gas detection, process safety and diffuse emissions

Chemical and petrochemical sites combine ATEX risks, volatile organic compound emissions and process safety obligations arising from the Seveso III Directive. CDL-Tecora supplies toxic and combustible gas detectors as well as emissions monitoring instruments suited to these classified environments.

Key facts

  • Seveso III DirectiveProcess safety framework
  • ATEX certifiedEquipment
A chemical or petrochemical site combines several measurement challenges: detection of toxic or combustible gases for personnel safety (ATEX zones), monitoring of channelled and diffuse emissions of volatile organic compounds, and combustion control of process heaters and flares. The Seveso III Directive (2012/18/EU) requires a major accident prevention policy for hazardous sites, and the ATEX Directive (2014/34/EU) governs the equipment that can be used in explosive atmospheres.

ATEX zones

Detection equipment certified for explosive atmospheres

Multi-gas detection

Toxic and combustible gases depending on the nature of the process

Diffuse VOC emissions

A specific challenge for refining and specialty chemicals sites

LDAR programmes

Leak detection and repair, complementing fixed detectors

Sector challenges

Business challenges

Leak detection in hazardous areas

A faulty or poorly positioned gas detector delays the detection of a toxic or combustible leak.

Diversity of gases to monitor

Each chemical process has a different gas risk profile, requiring suitable sensors.

Seveso III compliance

Major-hazard sites must demonstrate a documented, auditable accident prevention policy.

Fugitive emissions that are hard to locate

Leaks at flanges, valves and fittings are not always picked up by fixed detectors alone, hence the growing use of infrared imaging (OGI) to complement LDAR rounds.

Regulatory framework

Applicable standards and regulations

Directive 2012/18/EU (Seveso III)

Prevention of major accidents involving dangerous substances

Directive 2014/34/EU (ATEX)

Equipment intended for use in explosive atmospheres

Directive 2010/75/EU (IED)

Industrial emissions

Frequently asked questions

FAQ

Have questions about this sector? Here are the most frequent answers.

Another question?
What types of gas do CDL-Tecora detectors monitor at a chemical site?

Depending on the model, toxic and/or combustible gases: the T100/CGS500 range and the S500L-IR standalone detectors cover the main risk profiles encountered in chemicals and petrochemicals.

What is an ATEX zone and why must equipment be certified for it?

An ATEX zone is an area where an explosive atmosphere may form (flammable gases, vapours or dusts): any electrical equipment installed there must be certified so that it does not become a source of ignition.

What is the difference between channelled and diffuse emissions?

Channelled emissions are released through an identifiable stack or duct and can be measured continuously at that precise point. Diffuse emissions come from leaks, flanges or non-channelled equipment. Their detection requires different instruments, often portable or positioned as close as possible to potential sources.

Is flare combustion control part of a site's environmental monitoring?

Yes: flares and process heaters burn process gases and must be monitored like any other emission source, with combustion gas measuring instruments suited to the temperature and pressure conditions encountered on this type of equipment.

A project in this sector? Our experts are ready to help.

Personalised advice, a fast quote and technical support to choose the solution suited to your challenge.