
On-Site Installation & Qualification
A commissioning that doesn't stop at the factory gate
CDL-Tecora's on-site installation & qualification service covers connecting the instrument to its real measurement point, configuring it according to the actual site conditions (process, environment, access constraints), then verifying that the instrument works correctly under its real conditions of use, not just under the standardised conditions of a factory test. The intervention is carried out by a CDL-Tecora application engineer, on site at the customer's premises.
Key facts
- On site, at the customer's premisesResponse
- Under real conditions of useVerification
- Dedicated application engineerSupport
Connection to the real measurement point
Physical installation of the instrument at the customer's site, adapted to site constraints rather than a generic layout
Configuration according to site conditions
Setup adjusted to the process, the environment and the nature of the measurement actually concerned
Verification under real conditions of use
Check that the instrument works correctly once installed, not only during its factory test
Support from an application engineer
A technical contact on site, attentive to the customer at every stage
Process
How it works
Preparation
Preliminary discussion with the customer about the measurement point concerned: process, environment, access or connection constraints, in order to prepare a suitable installation rather than a standard intervention.
On-site installation
A CDL-Tecora application engineer connects the instrument directly to the customer's measurement point, under its real operating conditions.
Configuration
The instrument is configured according to the actual characteristics of the site and the expected measurement, not a generic factory setting.
Qualification and return to service
Verification that the instrument works correctly under its real conditions of use before handover to the customer, with a commissioning report documenting the installation and configuration carried out.
Go further
Related services
FAQ
Have questions about this service? Here are the most frequent answers.
Another question?How does on-site qualification differ from a simple factory test?
The factory test validates the instrument's operation under standardised, controlled conditions. On-site qualification, on the other hand, checks that it works correctly under its real conditions of use at the customer's site. The actual process, environment and measurement point almost always differ from the test bench.
Who carries out the on-site installation and qualification?
A CDL-Tecora application engineer travels to the customer's site. They are a technical contact attentive to the customer at every stage, not merely someone carrying out a standard procedure.
Does this service apply only to the first commissioning of a new instrument?
That is the main use case, but the same logic applies when an existing instrument is moved to a new measurement point or when the process conditions have changed significantly: on-site configuration and verification remain necessary.
Is this service available outside France?
CDL-Tecora operates directly in France and relies on qualified distributors in Spain, Portugal and Germany, with development under way in the United Kingdom.
Does the configuration take into account the standards applicable at the measurement point?
Yes: the application engineer draws on CDL-Tecora's standards expertise in the EN, ISO, US EPA and VDI standards that govern emissions sampling and measurement, in particular the requirements relating to the measurement point itself.
Is a document provided at the end of the intervention?
A commissioning report is provided, describing the installation carried out, the configuration applied at the measurement point and the verification performed before return to service.
A question about this service? Let's talk.
Our team will advise you on the option best suited to your instrument fleet.

