In-Situ Stainless Steel and Titanium Sampling Probes: Less Rinsing, Less UncertaintyProduct news

In-Situ Stainless Steel and Titanium Sampling Probes: Less Rinsing, Less Uncertainty

By positioning the filter holder directly in-situ, perpendicular to the flow, these probes eliminate the need to rinse the gooseneck and the probe tube — a direct gain in measurement uncertainty at low dust concentrations.

Updated on
Share

Rinsing, a Source of Uncertainty at Low Concentrations

In a conventional sampling train, some of the dust settles on the walls of the probe tube and gooseneck before reaching the filter — a deposit that must then be recovered by rinsing so as not to underestimate the concentration measured. This rinsing step, in addition to lengthening post-campaign processing time, itself introduces a source of uncertainty: incomplete rinsing underestimates the result, while excessive or poorly controlled rinsing can on the contrary bias it upwards. For a low-concentration dust measurement, where each source of uncertainty weighs proportionally more on the final result, this factor becomes significant.

The Filter Holder Positioned In-Situ: A Structural Solution

By placing the filter holder directly in the duct, with the filter perpendicular to the flow, these probes eliminate the intermediate deposit on the probe tube and gooseneck — and therefore the need to rinse them. The result: a direct reduction in measurement uncertainty and a lower limit of quantification, a particularly clear advantage for low-concentration dust measurements or particulate heavy metals.

Go further

Standards mentioned

Frequently asked

FAQ

Questions about this topic? Here are the most common answers.

Another question?
Why does eliminating rinsing reduce measurement uncertainty?

Rinsing aims to recover the dust deposited on the walls of the probe tube and gooseneck before analysis. Each manual recovery step introduces a risk of under- or over-estimation. By avoiding this intermediate deposit thanks to an in-situ filter holder, this source of uncertainty disappears structurally rather than merely being better controlled.

Are these probes compatible with measuring gaseous compounds in parallel?

Yes, via an adaptation kit, these in-situ probes can be combined with a heated version when the campaign also requires the determination of gaseous compounds, in addition to dust measurement.

A project to scope? Our experts can help.

Personalised advice and a fast quote for your measurement project.